AEM ETI Technology Enhances Cold Air Intake Performance

If you have been in the game of modifying cars for 10 years or so and got your start modding compact cars, you probably remember the good old days when adding a cold air intake was probably the first or second engine mod you did to your car. In those days a really well-designed intake could add as much as 10 or more whp to your car’s output and even the most basic, poorly designed ebay intake usually added at least a few dyno-verifiable horsepower. A cold air intake was considered to be a good bang for the buck modification and thousands were sold. Even the most mechanically inept were usually able to install an intake with a few simple hand tools.

aem1 aem2


Read the rest of the article at Moto IQ

 

 

GReddy Blow-Off Valve FV – "Floating Valve"

GReddy is proud to introduce a new generation of "Push Type Blow Off Valves," the GReddy BOV FV. The "FV" stand for Floating Valve, and it is this breakthrough in design that produces quicker valve…
Read More

aFe Takeda: Lexus IS-F Intake

When Lexus took a serious swing at the BMW M cars, their first attempt was nothing short of spectacular. To run with the Germans, the interiors had to be luxurious, suspensions had to be on-point…
Read More

Project E36 323is Suspension Overhaul

The next stage of our suspension overhaul—replacing dampers and springs—is where most of the handling magic happens. Internet legend would have you believe that the original dampers on most any E36 are shot at about…
Read More